TOYOSIGNAL

  • Conductor: Silicone
  • Pipe diameter:(9*15)x(25*33)
  • Temperature:-5~60oC
  • Pressure: 0~15
  • Country of origin: Japan
  • Status: Contact with us

Leave a phone number we will contact you!

・ Higher pressure resistance compared to the existing braided hose
(compared to TOYORON Hose) prevents puncture troubles
・ General piping compatible with a wide range of fluids including water, oil, chemical and air
・ Superior oil-resistant performance with long-lasting flexibility makes the product more durable, providing long service life
・ Very flexible and the piping work is made easy
・ The transparent line in the center of the hose makes the fluid visible for secure operations
・Safe and secure due to its compliance with corrected RoHS2 regulations
Working temperature range / -5~60℃

1. Be sure to use dedicated TOYOCONNECTOR couplings for hose couplings. The use of couplings other than TOYOCONNECTOR leads to risks of leakage and disconnection from fittings, and is not guaranteed.
2. When cutting a hose, make sure that the edge face of the hose is cut perpendicularly. If it is not perpendicular, the hose may leak or become disconnected.
3. When cutting a hose, make sure that the edge face of the hose is cut perpendicularly. If it is not perpendicular, the hose may leak or become disconnected. The hose can be used for water, air, oil, chemicals, and powder, but when using it with oils, chemicals, or powder, confirm chemical resistance data on the Toyox website or please consult with our Customer Advice Center.
※Do not use for fuel oil (heavy oil, kerosene (light oil), kerosene (lamp oil), gasoline) or solvents.
4. Do not use for food or beverages.
5. Please note that compounding agents such as ※2 plasticizers could be extracted / eluted from the hose depending on use conditions.
Please confirm the use conditions and the effects on your products before use.
6. Use the products within their working temperature range.
7. Use the products within their working pressure range.
8. Use hoses at bend angles larger than their ※3 minimum bending radius.
Angles smaller than the minimum bending radius may result in hose overbending or lower pressure resistance.
9. Do not use a hose that is extremely bent near a coupling.
10. Powders and granular materials may cause wear. Use a hose with as large a bending radius as possible.
11. Keep the hose away from open flame.
12. The life of hoses will be greatly affected by the physical properties, temperature, and flow rates of the fluid as well as by the frequency of pressurization and depressurization. If any of the following problems or similar signs are found in the pre-work or regular inspections, immediately cease use and repair or replace the hose.
○ Abnormalities near the fitting: Localized stretching, bending, leakage, bulging, or shallow insertion into the nipple
○ External damage: Large scratches in the outer surface, cracking, or water infiltrating the reinforcement layer
○ Internal abnormalities: Bulging or ※5 separation of the inner surface, or wear that leads to exposure of the hose reinforcement material. Note: In the case of abnormalities on the interior or exterior surface, hose scrapings and fragments of hose reinforcing materials may mix into the fluid inside the hose.
○ Other abnormal changes (stiffening, ※6 swelling, cracking, bulging, etc.)
13. Do not store outdoors or in a place subject to direct sunlight. This may cause the quality of the hose surface to deteriorate, becoming sticky and/or susceptible to cracking.Store in a low-humidity, well-ventilated place. Store keeping the inside of the hose free from foreign matter and dust.
14. Do not incinerate the hose. The incineration may generate toxic gases or damage incinerators; therefore, the hose should be treated as industrial waste for disposal purposes.
15. The hose should be disposed of in accordance with the requirements of the local region