HITRUN

  • Conductor: Silicone
  • Pipe diameter:(6.3*10)x(13.7*20.5)
  • Temperature:-20~60oC
  • Pressure: 0~1.5
  • Country of origin: Japan
  • Status: Contact with us

Leave a phone number we will contact you!

・ The surface sliding finish prevents the hose from tangling and improves the productivity.
・ Super lightweight, flexible and elastic. Easy to handle and improves the productivity.
・ Superior cold resistance property keeps the hose soft even during winter for improved productivity.
・ The elastic design prevents the hose from lifting up from the ground, keeping the feet safe.
・ Suitable for air hand tools (such as impact wrenches, air drivers, etc.)
・ Safe and secure due to its compliance with corrected RoHS2 regulations
Working temperature range / -20~60℃”

1. This is dedicated for air (pneumatic) use. Avoid using any other. ※Do not use for fuel oil (heavy oil, kerosene (light oil), kerosene (lamp oil), gasoline) or solvents.
2. Do not use for food or beverages.
3. Please note that compounding agents could be extracted / eluted from the hose depending on use conditions. Please confirm the use conditions and the effects on your products before use.
4. Use the products within their working temperature range.
5. Use the products within their working pressure range.
6. Use hoses at bend angles larger than their ※3 minimum bending radius. Angles smaller than the minimum bending radius may result in hose overbending or lower pressure resistance.
7. Keep the hose away from open flame
8. When cutting a hose, make sure that the edge face of the hose is cut perpendicularly. If it is not perpendicular, the hose may leak or become disconnected.
9. Use hose nipples suitable for the size of the hose. Do not use hose nipples with damaged or rusted surfaces
10. We recommend using TOYOX dedicated hose couplings and hose clamps. Be sure to use TOYOX dedicated couplings for HITRUN Hose. If TOYOX dedicated products are not used, air may leak or fittings come loose.
Retighten the hose clamp as necessary. Deformation of the plastic hose clamp fastening can cause air leakage and hose disconnection. Tightly fastening hose with wire may damage the inner or exterior surface of the hose and cause it to rupture
11. Do not use one-push fittings. Hose may rupture.
12. The life of hoses will be greatly affected by the physical properties, temperature, and flow rates of the fluid as well as by the frequency of pressurization and depressurization.
If any of the following problems or similar signs are found in the pre-work or regular inspections, immediately cease use and repair or replace the hose.
○ Abnormalities near the fitting: Localized stretching, bending, leakage, bulging, or shallow insertion into the nipple
○ External damage: Large scratches in the outer surface, cracking, or water infiltrating the reinforcement layer
○ Internal abnormalities: Bulging or ※5 separation of the inner surface, or wear that leads to exposure of the hose reinforcement material.
Note: In the case of abnormalities on the interior or exterior surface, hose scrapings and fragments of hose reinforcing materials may mix into the fluid inside the hose.
○ Other abnormal changes (stiffening, ※6 swelling, cracking, bulging, etc.)
13. Do not store outdoors or in a place subject to direct sunlight. This may cause the quality of the hose surface to deteriorate, becoming sticky and/or susceptible to cracking. Store in a low-humidity, well-ventilated place.
Store keeping the inside of the hose free from foreign matter and dust.
14. Do not incinerate the hose. The incineration may generate toxic gases or damage incinerators; therefore, the hose should be treated as industrial waste for disposal purposes.
15. The hose should be disposed of in accordance with the requirements of the local region.